Standard Series PA2/B

SMC designed the PA2 series of versatile tubular alloy masts with first hand experience of the tough environmental conditions so often encountered in the field. The PA2 has a section wall thickness of 7 SWG (4.2 mm) and will withstand dropping on rocky terrain or being run over by vehicles and yet is light and compact enough to be stored unobtrusively in a portable shelter or carried in a Land Rover.

Mast sections have expanded ends for easy assembly and quick erection by unskilled staff. For example, a three man team can erect the 48ft or 60ft mast in less than half an hour, following our practical installation instructions. See the operating instructions.

From a wide selection of stock components, masts can be supplied to suit customers' requirements, from a transportable mast complete with canvas carrying bags and all necessary hardware for erection, to installations for mounting permanently, complete with masthead and intermediate halyards, masthead lighting to ICAO standards, erection kit and all ground anchors.

Lightweight Series PA2/BML

As a development of the well established PA2 Series Masts, SMC introduced the lighter duty 2" OD x 14 SWG PA2 / BML Series for users who do not require the strength and ultra-rugged design associated with the 1 29/32" OD x 7 SWG PA2 / B Series Masts.

All mast sections in the PA2 / BML Series are expanded on one end, forming a female socket which ensures easy and quick assembly requiring no tools. All masts are supplied complete with necessary stays in 6mm pre-stretched polyester, ground steelwork, a halyard for wire antennas and unless specified, a carrying kit bag.

Available in 6' (2m) height increments from 24' (7.3m) to 48' (15m) the PA2 / BML masts are available on a very short delivery time, and can be adapted to suit customers' special requirements.

PA2 Headload and Wind Ratings

The standard headload for all masts is either:-

A) An antenna plus mountings having a windage area of 0.3 sq.m (= 67kg drag at 16Okph)

or:

B) A single wire VHF dipole or similar up to 30m long between supports and initial tension 30kg. Larger headloads or higher windspeeds to customers specification on application may be considered.