Service and Repair

Our fully equipped service and production facility enables us to service and repair all of the products we provide.


We regularly work on Codan, Hytera, Tait, and Motorola, from high power legacy HF systems through to IP linked digital radio networks.

Our skilled radio engineers repair, service and test a wide range of radio equipment with fault finding and repairs to component level.codan

SMC is officially appointed the Codan Service Centre for Europe, Middle East and Africa. Our Codan trained engineers ensure that your equipment is repaired in the most economical way, supported by what is probably the largest stock of Codan spares outside of Australia.

We provide in house training on radio principles, servicing and system planning, from the basics of radio propagation right through to hands-on component level fault finding.



We offer full service and repair options on all of our masts from a simple seal kit to replacement sections and full rebuilds.

With full fabrication facilities we are able to fully service and rebuild trailer systems.

We can install our masts through the roof or on a sliding roof carriage mounted on top of a vehicle. Typical vehicles which have this kind of installation are 4x4s and vans, however we can fit to almost anything, even lorry cabins and containers.

Not only do we fit the mast, but we offer our skills of interior design and fitment, creating a workspace and suitable facilities within the vehicle to the customers preference. Our interior fitments can range from a simple power inverter and split charger to a full installation.


We have full test, service and repair facilities for a wide range of antennas, both passive and active, as well as offering VSWR testing services, HF/VHF/UHF duplexer tuning and alignment. Our involvement in designing and manufacturing antennas for over 50 years has led to an experienced workforce in this field to provide customers with the very best service possible.

EMC Testing

SMC can help you achieve EMC compliance of your products. Our personnel have expert knowledge on EMC regulations and test methods as well as LVD requirements, to help you achieve the ‘CE’mark on your product. SMC can also offer a test service for many forms of electrical and electronic equipment. For EMC testing we have a Seaward MACE and capacitive coupling clamp for ESD (Electrostatic Discharge), voltage dips and interruptions, plus induced signals to coupling cables to your equipment, and RF spectrum analysis measurement capabilities.

SMC is ISO9001 registered, and over the past 20 years of radio compliance and EMC testing, we have achieved a 100% success rate for all our clients.